After drying a for a couple days I attach the hinges lid.
On the other side I attach over center latches. They have tabs that stick out to lock with a padlock.
Next I build the rear door.
I use clamps to hold the door in place where I can mark where the door hinges will bolt to.
I drill the holes and bolt everything together.
Welded on some shock mounts then finished painting underneath and inside the box.
The latch arrived today for the rear door. So now I can finish that up.
After the paint dried I attached the springs and axle.
Then set it down on some wheels and the jack.
Next I plasma cut a hole for the latch on the rear door.
I attach the door back on the trailer to figure out how to add a catch.
I had an old cut out from another project that worked perfectly. 3/8 inch plate.
I added some carriage bolts to act as an adjustable stop for the door.
Rear door ready for paint now.
I tossed some gear on the trailer so I have an idea on how to lay everything out and what brackets I’ll need.